Quantum-composers 9250 Series Manual do Utilizador descarregar pdf (Página 28)

9250 Manual Version 1.2 | Quantum Composers

Pressing the unit’s Run/Stop button will place the unit into active mode and generate a single

pulse on the enabled channels. Pressing the unit’s Run/Stop button again will take the unit

out of the active state (which will not produce a pulse). Continue this process for additional

single pulses. See “Output Examples” for a visual representation.

Channel Burst Mode

The burst mode generates a burst of pulses every time the unit is placed into active mode. To

use the channels’ burst mode set the following parameters in the 9250 application:

 Within the System section:

o Set the mode to Continuous.

o Set the desired Period.

 Within the Channel section:

o Set the mode to Burst.

o Set the Burst parameter to the number of pulses to produce during the on cycle

(‘N’).

o Enter the required pulse width and delay. Repeat for each output channel.

o Enable the corresponding channels by clicking “Enabled” in the 9250 application.

Pressing the unit’s Run/Stop button will place the unit into active mode and generate a burst of

pulses on the enabled channels. Pressing the unit’s Run/Stop button again will take the unit

out of the active state (which will not produce a burst). Continue this process for additional

bursts. See “Output Examples” for a visual representation.

Channel Duty Cycle Mode

The channel duty cycle mode will generate a stream of pulses on the channel level which will

repeat on for ‘N’ pulses and off or ‘M’ pulses. To generate the stated sequence of pulses set

the following parameters in the 9250 application:

 Within the System section:

o Set the mode to Continuous.

o Set the desired Period.

 Within the Channel section:

o Set the On parameter to the number of pulses to produce during the on cycle

(‘N’).

o Set the Off parameter to the number of pulses to suppress during the off cycle

(‘M’).

o Enter the required pulse width and delay. Repeat for each output channel.

o Enable the corresponding channels by clicking “Enabled” in the 9250 application.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 50 51

Sem comentários

Quantum-composers 9250 Series Manual do Utilizador Página 28