Quantum-composers 9530 Series Manual do Utilizador descarregar pdf (Página 39)

9530/8530 Manual Version 4.8 Page 39

Keyword:

Command:

Sub-

Command:

Parameter

Range:

Notes:

:PULSe[0]

Command to change the units’ global settings, this

is the same as using the :SPULse command

:OCLock

/ RATE /

CHAN / AUX1-4 /

DIS

Allows the user to select the clock source to output:

When ICLock is INT:

is the user defined period.

Rate = N/A

CHAN = N/A

AUX1 = 40 MHz

AUX2 = 20 MHz

AUX3 = 10 MHz

AUX4 = 5 MHz

When ICLock is in EXT:

is disabled

RATE = f

output

will be f

input

CHAN = f

output

will be 2x f

input

AUX1 = 2x EXT PLL

AUX2 = 1x EXT PLL

AUX3 = 1/2 EXT PLL

AUX4 = 1/2 EXT

:GATe

Command to change the units’ global gate settings.

:MODe

DIS / PULS /

OUTP / CHAN

Sets the global gate mode for the unit: When in

pulse inhibit mode if the pulse has started before

the gate is seen the output pulse will finish, but any

further pulses will be prevented, In output inhibit

mode if a pulse has started it will be truncated as

soon as the gate signal is seen and will prevent any

further pulses, and when in channel mode each

channel can be setup individually (be aware of

insertion delay for each mode, this is listed in the

appendix)

:LOGic

LOW / HIGH

Choose active Low (will allow pulses when low) or

active High (will allow pulses when high)

:EDGe

RISing / FALLing

Choose the edge of the incoming pulse to trigger

on. (Only used when the option for the gate to be a

second trigger input is enabled)

:LEVel

.20 – 15[V]

Choose the gate level threshold to trigger on, this

should be set to ~ 50% of the input potential

:TRIGger

Command to change the units’ global trigger

settings.

:MODe

DIS / TRIG /

DUAL

Sets the global trigger mode for the unit:

When the unit is set to single pulse each trigger

input will produce a output pulse, When in burst

mode each trigger input will produce a burst of

output pulses, and when in continuous or duty

cycle mode the trigger input will start the pulses

(the trigger will function the same as pressing the

Run/Stop button)

*Note: When in dual trigger mode each channel will

have the option to select which trigger to use.

:EDGe

RISing / FALLing

Choose the edge of the incoming pulse to trigger

on.

:LEVel

.20 – 15[V]

Choose the gate level threshold to trigger on, this

1 2 ... 34 35 36 37 38 39 40 41 42 43 44 ... 70 71

Comentários a estes Manuais

Sem comentários

Quantum-composers 9530 Series Manual do Utilizador Página 39

Comentários a estes Manuais

Manuais e produtos relacionados com Geradores Quantum-composers 9530 Series