Quantum Composers 9730 Series Instruções de Operação descarregar pdf (Página 28)

9-28

 Verify the rear panel Safety Interlock.

 Turn Arm Switch to ‘ARM’ Position.

 Press the FUNC key and then the PRE key (‘.’ on the numeric keypad) to run the

pre pulse resistance test.

 Refer to Testing Mode Error Conditions for more information on any resulting

errors.

Post Pulse Resistance Testing

The 9730 allows the user to setup a post pulse resistance test that, when enabled, may

be run at any time to verify the resistance of the connected load is greater than a user

specified minimum. To use pre pulse resistance testing:

 Setup the system mode, period and channel pulse parameters as described in

the Standard Operation Modes section.

 In the Channel Test Menu:

o Set PstTest to ‘Enabled’

o Set PstMin to the minimum resistance expected for a “fired” device.

 Verify the rear panel Safety Interlock.

 Turn Arm Switch to ‘ARM’ Position.

 Press the FUNC key and then the POST key (‘.’ on the numeric keypad) to run

the post pulse resistance test.

 Refer to Testing Mode Error Conditions for more information on any resulting

errors.

Testing Mode Error/Status Conditions

 Status - “No Error Detected” – This message is returned through a channel

error query whenever no errors are detected for the current channel. Refer to

Channel Commands for more information channel queries.

1 2 ... 23 24 25 26 27 28 29 30 31 32 33 ... 47 48

Sem comentários

Quantum Composers 9730 Series Instruções de Operação Página 28